This 3D experience gives you the step by step process of replacing the Power Adapter Port and a Latitude 5400. The procedure will also include removing the Base Cover, Battery Cable, Power Connector Port and reinstalling them.
Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover to the system base.
Using a plastic scribe or a flat head screwdriver, pry the base cover from the edges.
Lift the base cover off the system base.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Power Connector Port
Install
Power Connector Port
Battery Cable
Identify the battery cable highlighted in blue.
Route the battery cable through the routing clip and connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover tabs to the slots on the edges, press the edges of the cover until it clicks into place.
Tighten the captive screws that secures the base cover to the system base.