Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover to the palm rest assembly.
Use a plastic scribe to pry open the base cover at the gap near the display hinges.
Use a plastic scribe to pry open the base cover, inserting it at intervals to release the top, left, right, and bottom edges.
Lift the base cover off the palm rest assembly.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Battery
Identify the battery highlighted in blue.
Remove the screws that secure the battery to the palm rest assembly.
Lift the battery off the palm rest assembly.
Flip the battery.
Peel back the battery cable from the battery.
Disconnect and remove the battery cable from the battery.
Install
Battery
Identify the battery location highlighted in blue.
Place and connect the battery cable to its connector on the battery.
Adhere the battery cable to the battery.
Flip the battery.
Align and place the battery into the slot on the palm rest assembly.
Install the screws that secure the battery to the palm rest assembly.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align and place the base cover on the palm rest assembly, and snap it into place.
Tighten the captive screws to secure the base cover to the palm rest assembly.