Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the screws on the base cover.
Remove the screws that secure the base cover to the system.
Using a plastic scribe, pry the base cover from the hinges around the outside to loosen.
Lift the base cover off the palm rest and keyboard assembly.
Memory module
Identify the memory modules highlighted in blue.
Peel back the mylar to access the memory module.
Using your fingertips, carefully spread apart the securing clips on each end until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board.
Install
Memory module
Identify the memory modules location highlighted in blue.
Peel back the mylar to access the memory module.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Base Cover
Identify the base cover location highlighted in blue.
Place the base cover on the system and snap into place.
Tighten the screws that secure the base cover.
Install the screws that secure the base cover to the system.