Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the screws on the base cover.
Remove the screws that secure the base cover to the system.
Using a plastic scribe, pry the base cover from the hinges around the outside to loosen.
Lift the base cover off the palm rest and keyboard assembly.
Battery Cable
Identify the battery cable highlighted in blue.
Peel the tape that secures the battery cable.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Display Assembly
Identify the display assembly highlighted in blue.
Peel off the tape that secures the display cable to the system board.
Open the latch, and disconnect the display cable from the system board
Remove the screws that secure the hinges to the system.
Open the left and right hinges up slightly.
Slide the palm rest and keyboard assembly carefully off the display assembly.
Install
Display Assembly
Place the display assembly on a clean and flat surface with the display panel facing up.
Identify the display assembly location highlighted in blue.
Align and slide the palm rest and keyboard assembly under the display hinges
Press the display hinges down and align the screw holes on the system.
Install the screws that secure the hinges to the system board.
Connect the display cable to the system board. Close the latch to secure.
Adhere the tape to secure the display cable.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Adhere the tape that secures the battery cable.
Base Cover
Identify the base cover location highlighted in blue.
Place the base cover on the system and snap into place.
Tighten the screws that secure the base cover.
Install the screws that secure the base cover to the system.