Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Pry the base cover near the hinges. Pry from recess points near the hinges.
Loosen the base covery by working on the left, right and, bottom sides to open the base cover.
Lift to remove the base cover.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the connector on the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Wireless Module (WLAN)
Display assembly
Identify the display assembly highlighted in blue.
Peel off the tape that secures the display cable to the system board.
Lift the latch and disconnect the display cable from the connector on the system board.
Lift the palmrest assembly off the display assembly.
Install
Display assembly
Place the display assembly on a clean and flat surface with the display panel facing up.
Identify the display assembly location highlighted in blue.
Align and place the display assembly on the palm rest assembly.
Connect the display cable to the system board and close the latch.
Adhere the tape to secure the display cable to the system board.
Wireless Module (WLAN)
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover tabs to the slots, press the cover until it clicks into place.
Tighten the screws to secure the base cover to the chassis.