Removal
BOSS N1 card carrier
Identify the BOSS N1 card carrier highlighted in blue.
Pull and lift the BOSS N1 card carrier retention latch lock to open.
Slide the BOSS N1 card carrier out.
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
BOSS Module
Identify the BOSS module highlighted in blue.
Disconnect the BOSS N1 power cable and signal cable from the BOSS module.
Remove the screw that secures the BOSS N1 module on Riser 1.
Slide the BOSS N1 module towards the front of the chassis and lift the module.
Install
BOSS Module
Identify the BOSS module location highlighted in blue.
Insert the BOSS N1 controller card module and push the module towards the rear of the system until it is secured.
Install the screw to secures the BOSS N1 module on Riser 1.
Connect the BOSS power and signal cable to the connectors to the BOSS module.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a flat head or Phillips screwdriver, rotate the lock clockwise to the lock position.
BOSS N1 card carrier
Identify the BOSS N1 card carrier location highlighted in blue.
Slide the BOSS N1 card carrier into the BOSS N1 module slot.
Close the BOSS N1 card carrier release latch to lock the carrier in place.