Removal
Left side cover
Place the computer in an upright position as shown in the AR.
Identify the left side cover highlighted in blue.
Loosen the captive screw that secures the left side cover release latch to the chassis.
Pull the left side cover release latch to release the left side cover away from the chassis.
Lift the left side panel from the chassis.
Right side cover
Identify the right side cover highlighted in blue.
Pull and lift the right side cover away from the chassis.
Single graphics card
Identify the single graphics card highlighted in blue.
Disconnect the graphics card power cables from the graphics card.
Lift the pull tab and open the expansion card door.
Push the securing tab on the PCIe slot on the system board away from the graphics card.
Grasp the card by its top corner, and ease it out of the slot.
Power supply unit
Identify the power supply unit highlighted in blue.
Press the release clips on the power supply connectors and disconnect the power supply cable from the system board.
Press the release clips on the power supply connectors and disconnect the power supply cables from the extention cables.
Unroute the power upply unit cables from the securing clip.
Unroute the GPU cables from the power supply unit bracket.
Place the computer in an upright position.
Unroute the power supply unit cables from the securing clip on the chassis.
Lay the computer on the right side.
Remove the screws that secure the power supply unit bracket to the power supply unit.
Slide and lift the power supply unit bracket from the power supply unit.
Remove the screws that secure the power supply unit to the chassis.
Slide and lift the power supply unit, along with the cables, off the chassis.
Install
Power supply unit
Identify the power supply unit location highlighted in blue.
Slide and place the power supply unit on the chassis.
Install the screws that secure the power-supply unit to the chassis.
Align and place the power supply unit bracket on the power supply unit.
Install the screws that secure the power supply unit bracket to the power supply unit.
Place the computer in an upright position.
Route the power supply unit cables to the securing clip on the chassis.
Lay the computer on the right side.
Route the GPU cables to the power supply unit bracket.
Route the power upply unit cables through the securing clip.
Connect the power supply cables to the power supply unit extention cables.
Connect the power supply cable to the system board.
Single graphics card
Identify the single graphics card location highlighted in blue.
Place the card into the PCIe slot and press down firmly until the single graphics card snaps into place.
Close the expansion card door and snap the latch back into position.
Connect the graphics card power cables to the graphics card.
Right side cover
Identify the right side cover location highlighted in blue.
Align the tabs on the right side cover with the slots on the chassis.
Push the right side cover towards the chassis until it snaps into place.
Left side cover
Identify the left side cover location highlighted in blue.
Locate the tabs on the left side cover and slots on the chassis.
Rotate the left side cover towards the chassis until it snaps into place.
Install the release latch to secure the left side cover to the system.
Tighten the captive screw that secures the left side cover release latch to the chassis.