Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the screws that secure the base cover to the palm rest assembly.
Remove the screws that secure the base cover to the palm rest assembly.
Pry the base cover starting from the top left corner at the hinge and continuing on all sides to loosen it from the palm rest assembly.
Remove the base cover from the palm rest assembly.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
USB Type-C Bracket
Identify the USB type-C bracket highlighted in blue.
Remove the screws that secure the right display hinge to the palm rest assembly.
Open the right display hinge at an angle of 90 degrees.
Remove the screws that secure the USB type-C bracket to the system.
Remove the USB type-C bracket off the system.
Install
USB Type-C Bracket
Identify the USB type-C bracket location highlighted in blue.
Install the USB type-C bracket on the system.
Install the screws that secure the USB type-C bracket to the system.
Close the right display hinge and align it with the screw holes.
Install the screws that secure the right display hinge to the palm rest assembly.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover and press the edges of the cover until it clicks into place.
Tighten the screws that secure the base cover to the palm rest assembly.
Install the screws that secure the base cover to the palm rest assembly.