Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover to the palm rest assembly.
Pry open the base cover from the recesses that are located in the U shaped indents at the top edge of the base cover near the hinges.
Lift the base cover off the palm rest assembly.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Wireless Card (WWAN)
Display Cable
Identify the display cable highlighted in blue.
Remove the screws that secure the display cable bracket to the system board.
Lift the display cable bracket off the system board.
Display Assembly
Identify the display assembly highlighted in blue.
Remove the screw that secures the fingerprint reader bracket to the I/O board.
Remove the fingerprint reader bracket from the I/O board.
Disconnect the darwin cable from the I/O board.
Open the display assembly at an angle of 90 degrees and place the system on flat surface as shown.
Remove the screws that secure the left and right display hinges to the palm rest assembly.
Remove the display assembly off the palm rest assembly.
Install
Display Assembly
Identify the display assembly location highlighted in blue.
Align it with the screw holes and place the display assembly on the palm rest assembly.
Install the screws that secure the left and right display hinges to the palm rest assembly.
Close the display assembly onto the palm rest assembly and place the system on flat surface as shown.
Connect the darwin cable to the I/O board.
Install the fingerprint reader bracket on the I/O board.
Install the screw that secures the fingerprint reader bracket to the I/O board.
Display Cable
Identify the display cable location highlighted in blue.
Install the display cable bracket on the system board.
Install the screws that secure the display cable bracket to the system board.
Wireless Card (WWAN)
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align and place the base cover on the palm rest assembly and snap it into place.
Tighten the captive screws that secure the base cover to the palm rest assembly.