Removal
Stand
Place the system on the flat and clean surface as shown.
Identify the stand highlighted in blue.
Press and hold down on the tab that secures the stand to the display assembly base.
Lift the stand off the display assembly base.
Back Cover
Identify the back cover highlighted in blue.
Place your palm in the middle of the back cover, and then pry the back cover from the display assembly base starting from the top corners.
Slide and lift the back cover off the display assembly base.
I/O Cover
Identify the I/O cover highlighted in blue.
Remove the screws that secure the I/O cover to the display assembly base.
Lift the I/O cover off the display assembly base.
System Board Shield
Identify the system board shield highlighted in blue.
Remove the screws that secure the system board shield to the display assembly base.
Lift the system board shield off the display assembly base.
Retractable Camera Assy
Identify the retractable camera assembly highlighted in blue.
Disconnect the camera cable from the system board.
Peel the tape that secures the camera cable to the display assembly base.
Remove the screws that secure the retractable camera assembly to the display assembly base.
Slide and remove the camera assembly from the display assembly base.
Install
Retractable Camera Assy
Identify the retractable camera assembly location highlighted in blue.
Slide and place the retractable camera assembly on the display assembly base.
Install the screws that secure the retractable camera assembly to the display assembly base.
Adhere the tape that secures the camera cable to the display assembly base.
Connect the camera cable to the system board.
System Board Shield
Identify the system board shield location highlighted in blue.
Place the system board shield on the display assembly base and align with screw holes.
Install the screws that secure the system board shield to the display assembly base.
I/O Cover
Identify the I/O cover location highlighted in blue.
Place the I/O cover on the display assembly base and align with screw holes.
Install the screws that secure the I/O cover to the display assembly base.
Back Cover
Identify the back cover location highlighted in blue.
Align the back cover to the display assembly base.
Press along the sides to snap the back cover into place on the display assembly base.
Stand
Identify the stand location highlighted in blue.
Align the stand to the slot with the display assembly base.
Insert the stand into place into the slot on the display assembly base.