Removal
Base Cover
Identify the base cover highlighted in blue.
Remove the screws that secure the base cover to the system.
Loosen the captive screws on the base cover.
Using a plastic scribe, pry the base cover near the hinges to release it from the system.
Remove the base cover by loosening the sides and front.
Battery Cable
Identify the battery cable highlighted in blue.
Peel the tape and disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Display assembly
Identify the display assembly highlighted in blue.
Peel the tape that secures the display cable connector latch to the system board.
Lift the latch and disconnect the display cable from the system board.
Remove the screws that secure the display hinges.
Lift to open the display hinges.
Slide the palm rest and keyboard assembly carefully off the display assembly.
Install
Display assembly
Place the display assembly as shown in video.
Identify the display assembly location highlighted in blue.
Align and slide the palm rest and keyboard assembly under the display hinges.
Close the display hinges and align the screw holes.
Install the screws to secure the hinges.
Connect the display cable to the system board, close the latch
Adhere the tape that secures the display cable connector.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the system board and adhere the tape.
Base Cover
Identify the base cover location highlighted in blue.
Install the base cover and press the edges and sides until it snaps into place.
Tighten the screws captive that secure the base cover.
Install the screws that secure the base cover to the system.