Removal
Base Cover
Identify the base cover highlighted in blue.
Loosen the captive screws that secure the base cover.
Pry the base cover near the hinges to release it from the system.
Remove the base cover by loosening the sides and front.
Battery Cable
Identify the battery cable highlighted in blue.
Using the pull tab, lift up to disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Battery
Identify the battery highlighted in blue.
Loosen the screws that secure the battery.
Lift the battery to remove from the system.
Speaker
Identify the speaker highlighted in blue.
Disconnect the speaker cable from the system board.
Peel the tapes that secures speaker cable
Unroute the speaker cable from the routing guides on the system.
Remove the speaker and cable. To assist, use a plastic scribe to lift near the rubber bumpers.
Install
Speaker
Identify the speaker location highlighted in blue.
Install the speakers in the slots on the system, using the alignment posts as a guide.
Route the speaker cable through the routing guides. Adhere the tape to secure.
Adhere tapes to secure the Speaker cable
Connect the speaker cable to the system board.
Battery
Identify the battery location highlighted in blue.
Insert the battery into the slot on the system and align the screw holes.
Tighten the screws to secure the battery.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover tabs to the slots, press the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system.