Removal
Base Cover
Identify the base cover highlighted in blue.
Using a Torx #5, remove the screws that secure the base cover to the system.
Place fingers into the recess at the top edge and move your hands to both sides to pry the base cover.
Lift the base cover off the system.
Battery Cable
Identify the battery cable highlighted in blue.
Loosen the screw that secures the battery connector bracket to the palm rest assembly.
Unhook and lift the battery connector bracket off the system board.
Using the pull tab, disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Battery
Identify the battery highlighted in blue.
Remove the screws that secure the battery to the system.
To remove, use the pull tab to lift the battery slightly and release it from the two hooks on the bottom edge.
Install
Battery
Identify the battery location highlighted in blue.
Align the battery at an angle so that the tabs fit into the hooks. Lower the battery and align the screw holes.
Install the screws to secure the battery to the system.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector to the system board.
Slide the hook under the system board and install the bracket to the system board.
Tighten the screw that secures the battery connector bracket to the palm rest assembly.
Base Cover
Identify the base cover location highlighted in blue.
Align the base cover and press the edges of the cover until it clicks into place.
Using a Torx #5, install the screws that secure the base cover to the system.