Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Airshroud
Low profile right riser
Identify the low profile right riser highlighted in blue
Hold the touch points and lift the expansion card riser from the riser connector on the system board.
Position the riser so that the expansion card will be visible to remove.
Open the expansion card latch
Remove the expansion card from the riser and the remaining part is low profile right riser.
Low profile left riser
Identify the low profile left riser highlighted in blue
Hold the touch points and lift the expansion card riser from the riser connector on the system board.
Position the riser so that the expansion card will be visible to remove.
Open the expansion card latch
Remove the expansion card from the riser and the remaining part is low profile left riser.
LOM riser card
Identify the LOM riser card highlighted in blue
Loosen the screws that secure the LOM riser card to the system board.
Release the two blue side plastic snaps holding the LOM riser card.
Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
Slide the LOM riser card towards the front of the system until the Ethernet connectors or the Small form-factor pluggable (SFP) are clear of the slot in the back of the system.
Install
LOM riser card
Identify the LOM riser card location on the system board.
Align the connectors on the LOM riser card with the slot on the system.
Press the LOM riser card until the card is firmly seated on the system board connector and the two blue plastic snap hold the LOM riser card in place.
Tighten the screws to secure the LOM riser card to the system board.
Low profile left riser
Identify the low profile left riser location highlighted in blue
Position the riser to install the expansion card.
Insert the expansion card into the expansion card connector until the card is fully seated.
Close the expansion card latch
Lower the low profile left riser until the riser connector is fully seated in the connector of the system board.
Low profile right riser
Identify the low profile right riser location highlighted in blue
Position the riser to install the expansion card.
Insert the expansion card into the expansion card connector until the card is fully seated.
Close the expansion card latch
Lower the low profile right riser until the riser connector is fully seated in the connector of the system board.
Airshroud
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a flat head or Phillips screwdriver, rotate the lock clockwise.