Stack 2 N1108 switches

Question

I have 2 N1108EP-ON switches and would like to stack them using the SFP+ ports.  I see in the manual for the N series switches that it can be done on the N1100-ON series, but I can't find what exactly I need to do.  I'm assuming I can use 1 gig fiber transceivers, but what commands would I need to use to specify the ports. I tried: config stack stack-port gi1/0/11 stack But this did not work.  Can someone explain to me how to stack the N1108 switches?

DELL-Joey C · Answer

Hi @cepacs,   Unfortunately, there is no stacking support for N1108. Page 231: https://dell.to/3QhhmWC

jerryxu · Answer

There is no SPF+ ports for N1108.

N1108T-ON: 8x 10/100/1000Mbps half/full duplex RJ45 ports, 2x GbE RJ45 and 2x GbE SFP interfaces, 1 RU half-width form factor, fanless operation
N1108P-ON: 8x 10/100/1000Mbps half/full duplex ports, 2x GbE RJ45 and 2x GbE SFP interfaces, 4xPoE/PoE+, 75W PoE power budget RJ45, 1 RU half-width form factor

https://i.dell.com/sites/csdocuments/Shared-Content_data-Sheets_Documents/en/aa/Dell-EMC-Networking-N1100-Series-Spec-Sheet.pdf

Networking General

Was this post helpful?