Storage, Drives & Media

Last reply by 06-22-2012 Solved
Start a Discussion
2 Bronze
2 Bronze
11450

Adding a SSD to a XPS 435MT

Hello all,

I'd like to to replace my Windows 7 boot partition HD with a SSD to my XPS 435MT. I believe the XPS 435MT maximally supports SATA-2 natively.

Other than the SSD and cabling, what do I need to upgrade the XPS to support SATA-3's speed of 6Gb/s? Is it even possible?

Kind thanks,

Daniel

Solution (1)

Accepted Solutions
6 Thallium
699

The XPS 435MT SATA interface is limited to 3 GB/sec by its hardware, but it will still accept drives that are capable of 6 GB/sec.  The higher, 6 GB/sec, interface speed requires the Sandy Bridge architecture that became available with the XPS 8300.

Dell Forum member since 2005

View solution in original post

Replies (7)
6 Thallium
700

The XPS 435MT SATA interface is limited to 3 GB/sec by its hardware, but it will still accept drives that are capable of 6 GB/sec.  The higher, 6 GB/sec, interface speed requires the Sandy Bridge architecture that became available with the XPS 8300.

Dell Forum member since 2005

2 Bronze
2 Bronze
699

Thank you kindly.

6 Thallium
699

You're very welcome.  Best of luck to you.

Dell Forum member since 2005

2 Bronze
2 Bronze
699

How do you tranfer your windows 7 to SSD? i want to do such work too.

2 Bronze
2 Bronze
699

What if he simply adds an additional card such as StarTech 2 Port SATA 3 PCI Express Controller Card

this should in theory all him to use the faster speed. What are your thoughts?

2 Bronze
2 Bronze
699

I was going to perform a fresh install from DVD; others may have a faster approach

2 Bronze
2 Bronze
699

I did pretty much that. I added an LSI MegaRAID SAS 9240-4i card because it supports RAID10 and installed 4 OCZ Vertex 3 120GB drives. Benchmarking, I went from ~100MB/s to ~850MB/s.

Latest Solutions
Top Contributor