NVX CLI is working but unable to login to GUI

Hello,

VNX 5200, I have been going through the CLI (I am new to this) trying to determine why I am unable to login to the device through an GUI interface. Here is a list of the installed software:

Name of the software package: -ODXCopy
Revision of the software package: -
Commit Required: NO
Revert Possible: NO
Active State: YES
Is installation completed: YES
Is this System Software: NO

Name of the software package: -SANCopy
Revision of the software package: -
Commit Required: NO
Revert Possible: NO
Active State: YES
Is installation completed: YES
Is this System Software: NO

Name of the software package: -Unisphere
Revision of the software package: -
Commit Required: NO
Revert Possible: NO
Active State: YES
Is installation completed: YES
Is this System Software: NO

Name of the software package: -UnisphereAnalyzer
Revision of the software package: -
Commit Required: NO
Revert Possible: NO
Active State: YES
Is installation completed: YES
Is this System Software: NO

Name of the software package: -UnisphereBlock
Revision of the software package: -
Commit Required: NO
Revert Possible: NO
Active State: YES
Is installation completed: YES
Is this System Software: NO

Name of the software package: VNX-Block-Operating-Environment
Revision of the software package: 05.33.009.5.231
Commit Required: NO
Revert Possible: NO
Active State: YES
Is installation completed: YES
Is this System Software: NO

This is an older device, but all out put seem to say that it is working properly, I ran a command that checked for errors, and was unable to find any.