Start a Conversation

Unsolved

J

295 Posts

846

July 14th, 2022 07:00

SCG 5.10, I must use yast to set IP?

Secure Connect Gateway - Virtual Edition

Secure Connect Gateway - Virtual Edition

Virtualization--> VMware board. Edits done to make it more readable. DELL-Admin>

Hello,

Any one had experience issue installing SCG version 5.10 virtual edition? The wizard in VMware setting parameter are not working? Because at this time I completed installation but I have to use yast to set ip address manual. Also the TCP port 5700 is not available? What commands do I need to run via cli to check consistency and if services are up and running?

1 Message

January 12th, 2023 08:00

Hi there, I have this same problem.  The VMware deployment parameters are not being set.   I also cannot log into the console via my root password.  Were you able to figure out the issue?

No Events found!

Top