Prerequisites
Follow the safety guidelines listed in the Safety instructions section.
Turn off the system, including any attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If installed, remove the front bezel.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the cooling shroud.
Replacing the system battery:
Locate the battery socket. For more information, see the Jumpers and connectors section.
CAUTION To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.
Place your finger between the securing tabs at the negative side of the battery connector, and lift the battery out of the socket.
To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs.
Press the battery into the connector until it snaps into place.
Install the system cover.
If applicable, install the system into the rack.
If removed, install the front bezel.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the system, including any attached peripherals.