How To Replace System Memory for PowerEdge 14th Generation Racks

This video will demonstrate replacement procedure of a System Memory for PowerEdge 14th Generation Racks.

Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.

Removing the air shroud:
Hold the air shroud at both ends and lift the air shroud out of the system.

WARNING: Allow the memory modules to cool after you power off the system. Handle the memory modules by the card edges and avoid touching the components or metallic contacts on the memory module.
CAUTION:To ensure proper system cooling in configurations with mid drive tray, memory module blanks must be installed in any memory socket that is not occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.
NOTE:You must follow the thermal restriction while using DIMM blank. For information about thermal restriction, see the Thermal restrictions section.

Removing a memory module:
Locate the appropriate memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or metallic contacts.
Push the ejectors outward on both ends of the memory module socket to release the memory module from the socket.
Lift and remove the memory module from the system.

Installing a memory module:
Locate the appropriate memory module socket.
CAUTION: Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or metallic contacts.
CAUTION: To prevent damage to the memory module or the memory module socket during installation, do not bend or flex the memory module. You must insert both ends of
the memory module simultaneously.
Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.
Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the memory module in the socket.
CAUTION:Do not apply pressure at the center of the memory module; apply pressure at both ends of the memory module evenly.
NOTE:The memory module socket has an alignment key that enables you to install the memory module in the socket in only one orientation.
Press the memory module with your thumbs until the socket levers firmly click into place.

Installing the air shroud:
Align the slot on the air shroud with the standoff on the chassis.
Lower the air shroud into the system until it is firmly seated.

Install the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet.
Turn on the attached peripherals and then turn on the system.
To verify if the memory module has been installed properly, press F2 and navigate to System Setup Main Menu > System BIOS > Memory Settings. In the Memory Settings screen, the System Memory Size must reflect the updated capacity of the installed memory.
If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module is firmly seated in the memory module socket.
Run the system memory test in system diagnostics.