Μετάβαση στο κύριο περιεχόμενο
Έξοδος

Καλώς ορίσατε στην Dell

Ο λογαριασμός μου
  • Υποβάλετε παραγγελίες γρήγορα και εύκολα
  • Δείτε τις παραγγελίες και παρακολουθήστε την κατάσταση αποστολής
  • Δημιουργήστε μια λίστα με τα προϊόντα σας για να έχετε πρόσβαση σε αυτή
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Είσοδος Δημιουργήστε έναν λογαριασμό Είσοδος στο Premier Είσοδος στο Πρόγραμμα συνεργατών
Επικοινωνία

Dell Chassis Management Controller for Dell EMC PowerEdge FX2 Version 2.10 Release Notes

PDF

Known Issues

  • Issue 1:

    Description

    PCIe card device name displayed on the iDRAC GUI and CMC GUI are not same for Broadcom/Qlogic 10G card.

    Resolution

    Refer to the iDRAC GUI, it is accurate and current.

    Versions/Systems Affected

    None

  • Issue 2:

    Description

    An error occurs while importing CMC configuration file using local racadm or remote racadm.

    Resolution

    This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6 using the command, racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0.

    Versions/Systems Affected

    CMC for PowerEdge FX2 1.10 or later

  • Issue 3:

    Description

    The value of "Power Available for Server Power-on” can increase after PSU failure and recovery, without any changes to the underlying chassis hardware components.

    Resolution

    For actual power consumption of the chassis, in the CMC GUI, navigate to the Chassis Overview > Power > Power Monitoring > System Input Power page.

    Versions/Systems Affected

    All the versions of FX2/FXs

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\