Μετάβαση στο κύριο περιεχόμενο
Έξοδος

Καλώς ορίσατε στην Dell

Ο λογαριασμός μου
  • Υποβάλετε παραγγελίες γρήγορα και εύκολα
  • Δείτε τις παραγγελίες και παρακολουθήστε την κατάσταση αποστολής
  • Δημιουργήστε μια λίστα με τα προϊόντα σας για να έχετε πρόσβαση σε αυτή
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Είσοδος Δημιουργήστε έναν λογαριασμό Είσοδος στο Premier Είσοδος στο Πρόγραμμα συνεργατών
Επικοινωνία

Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

PDF

Removing the Network Daughter Card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  3. Follow the procedure listed in the Before working inside your system section.

  4. Remove the PCIe mezzanine card.

Steps

  1. Remove the two screws that secure the Network Daughter Card (NDC) to the system board.
    CAUTION: To prevent damage to the NDC, you must hold the card only by its edges.
  2. Lift the card from the system board.
    Figure 1. Removing the NDC
    This figure shows removing the NDC.
    1. slot on the NDC
    2. screw (2)
    3. NDC
    4. standoff (2)
    5. connector
    6. tab projections

Next steps

  1. Install the NDC.

  2. Install the PCIe mezzanine card.

  3. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\