The following
table lists the supported backup and restore applications.
Table 1. Backup and Restore
Applications
Application
Supported Version
3-Way NDMP Support
CommVault Simpana
11
Yes
EMC Networker
9
Yes*
Veritas BackupExec
2016
Yes
Veritas NetBackup
7.7
Yes
* Level-based incremental backups are supported from the EMC
Networker CLI. Token-based backups are not supported.
Refer to the application documentation for the minimal revision/service
pack supporting Dell FluidFS systems.
The following
table lists the NDMP agent characteristics. Refer to the application
documentation for the minimum revision/service pack supporting Dell
FluidFS systems.
Table 2. NDMP Agent Characteristics
Functionality
Supported Range
NDMP version
v2, v3, v4
DMA address type
IPv4 only
DMA servers configured
Up to 10
Concurrent NDMP sessions per controller
Up to 48
DMA user-name length
1–63 bytes (accepts Unicode)
DMA password length
1–32 characters
Maximum number of include paths for an NDMP
job
32
Maximum number of exclude paths for an NDMP
job
32
NOTE: Your
environment should allow ICMP (ping) traffic between the FluidFS controllers’
private IP addresses (not the access VIPs) and the backup server.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\