WARNING: The weight
of your system without the physical disks installed (empty weight)
is 19.50 kg (43.0 lb) and when fully populated with all the physical
disks is 105.20 kg (232.0 lb).
WARNING: Your system
must be installed by Dell certified service technicians. For safe
installation of an empty system, a minimum of three service technicians
are required. To install a fully populated system, a mechanized lifting
tool is required to position the system in a rack.
WARNING: Install
the physical disks into the system only after installing the system
in the rack. Installing the system in the rack with the physical disks
installed can damage the disks or cause injury.
CAUTION: Before
installing your system in the rack, ensure that the weight of the
system does not exceed the rack's weight limit. For more information,
see the Rack Installation Instructions that shipped with your system.
NOTE: For weight stability,
always load the rack from the bottom up.
Figure 1. Installing the
System in a Rack
Unpack
your system and identify each item.
Assemble the rails and install
the system in the rack following the safety instructions and the rack
installation instructions provided with your system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\