ThinLinux image is a tar ball of raw image, kernel and initrd. The
raw image contains one ext4 read-write partition. The kernel and initrd
is downloaded to existing system and used for image upgrade during
next boot. ThinLinux can not be downgraded to SLETC11 SP3 using raw
image. To upgrade SLETC11 SP3 to ThinLinux, use DELAYED_UPDATE method.
To upgrade ThinLinux using raw image, the image files
should be on ftp or http server. The Server URL and upgrading options
can be configured through INI and or admin GUI. The ThinLinux image
supports Wyse 7020, Wyse 5020, Wyse 3030 LT, and Wyse 5060 platforms.
Raw image upgrade is done only through
delayed update. Delayed update is a service started by network. It
downloads the image and add-ons in background. Once it is ready, you
will be prompted to restart the device. After the system is restarted,
it is switched to upgrading mode, in which the hard drive is flashed
with the new image. The device is restarted into new system after
upgrading. The maximum size of the available storage is increased.
To upgrade from SLETC11, DELAYED_UPDATE add-on should
be a newer version. Upgrading SLETC follows the above steps but the
changes are not preserved when upgrading from SLETC SP3 to ThinLinux.
Downgrading ThinLinux back to SLETC11 is not supported by raw image.