Dell Chassis Management Controller Version 3.0 for PowerEdge VRTX RACADM CLI Guide

PDF

assignva


Description	Assigns a virtual disk to one or more virtual adapters. NOTE You can assign virtual disk to multiple virtual adapters when you select the mode of assignment as multiple. NOTE You can assign a virtual disk to multiple virtual adapters from CMC CLI even when the Assignment Mode is set to Single Assignment in the CMC web interface.
Synopsis	racadm raid assignva:<VA FQDD> -vdkey:<VD FQDD> -accesspolicy {na \| rw} -assignpolicy {single \| multiple}{-current \| -pending}
Input	–current <optional>: Performs the configuration right now. NOTE If this requires the system to reboot, the system reboots then. –pending: Save the configuration change for a later application. You can use a combination of the –pending and –current flags on multiple commands to reduce the possible number of system restarts. –assignpolicy {single\|multiple}: Uses the specified assign policy to determine if the virtual disk can be assigned to multiple virtual adapters. NOTE Enable cluster services on the servers when assigning virtual disk to multiple virtual adapters. Use of this mode without Cluster Services may lead to corrupted or lost data. –accesspolicy {na \| rw}: Set the access policy to No Access or Read/Write. –vdkey:<VD FQDD>: The virtual drive to change the access to.
Example	racadm raid assignva:RAID.ChassisIntegrated.1-1-1 -vdkey:Disk.Virtual.0:RAID.ChassisIntegrated.1-1 -accesspolicy { na \| rw } racadm raid assignva:RAID.ChassisIntegrated.1-1-2 -vdkey:Disk.Virtual.0:RAID.ChassisIntegrated.1-1 -accesspolicy rw -assignpolicy multiple