Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Your Dell.com Baskets

Dell PowerEdge R330 Owner's Manual

PDF

Removing the LCD control panel assembly

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the Phillips #2 screwdriver ready.

Steps

  1. Disconnect the cables from the control panel board.

    CAUTION: Do not use excessive force when removing the control panel as it can damage the connectors.

  2. Hold the top edge of the LCD control panel at the corners and pull upward until the LCD control panel tabs are released.
  3. Pull the control panel away from the chassis.
  4. Remove the screws securing the LCD control panel board.
  5. Lift the LCD control panel board away from the chassis.
    Figure 1. Removing the LCD control panel—four 3.5-inch hot swappable hard drive chassis
    This figure shows removing the LCD control panel—four 3.5-inch hot swappable hard drive chassis.

    1. LCD control panel

    2. notches (6)

    3. display module cable retention clip
    4. display module cable
    5. tabs on the LCD control panel (6)
    Figure 2. Removing the LCD control panel board—four hard drive chassis
    This figure shows removing the LCD control panel board.
    1. screw (2)
    2. control panel connector cable
    3. display module cable
    4. LCD control panel board
    5. USB connector cable
    6. standoff on the chassis (2)

Next steps

  1. Install the LCD control panel assembly.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\