You must configure
the initial network settings based on your network infrastructure
to enable the communication to and from iDRAC. You can set up the IP address by using one of the following
interfaces:
Interfaces
Document/Section
iDRAC Settings utility
See Dell Integrated Dell Remote Access Controller
User's Guide at Dell.com/idracmanuals
Dell Deployment Toolkit
See Dell Deployment Toolkit User’s Guide at Dell.com/openmanagemanuals
Dell Lifecycle Controller
See Dell Lifecycle Controller User’s Guide at Dell.com/idracmanuals
CMC Web interface
See Dell Chassis Management Controller Firmware
User’s Guide at Dell.com/esmmanuals
You must use the default iDRAC IP address 192.168.0.120 to configure the initial network
settings, including setting up DHCP or a static IP for iDRAC.
NOTE: To access iDRAC, ensure that you install the iDRAC port card or connect
the network cable to the Ethernet connector 1 on the system board.
NOTE: Ensure that you change the default user name and password after setting
up the iDRAC IP address.
NOTE: In case of server module, you can
configure the network setting by using the Chassis LCD panel only
during initial configuration of CMC. After the chassis is deployed,
you cannot reconfigure iDRAC by using the Chassis LCD panel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\