Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge T320 Systems Owner's Manual

PDF

Installing The Control-Panel Board For Systems With Diagnostic Indicators

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • NOTE: The control-panel assembly with diagnostic indicators is supported on systems with cabled hard drives and systems with an x8 backplane.
  1. Using the screw holes, align the control-panel board with the control-panel assembly.
  2. Secure the control-panel board to the control-panel assembly using the three screws.
  3. Install the control-panel assembly in the chassis.
  4. Close the system.
  5. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
  6. If applicable, install the front bezel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\