The hard drive
or SSD (Solid-State Drives) indicators display different patterns
as drive events occur in the system.
NOTE: The server module must have a hard drive or SSD or a hard drive blank installed in
each drive bay.
Figure 1. Hard drive or
SSD indicators
drive activity indicator (green)
drive status indicator (green and amber)
NOTE: If the
drive is in Advanced Host Controller Interface (AHCI) mode, the status
LED (on the right side) does not function and remains off.
Table 1. Drive status
indicator codesThe following table contains the drive LED indicator
pattern with the drive status.
Drive-status indicator pattern
Condition
Flashes
green twice per second
Identifying
drive or preparing for removal.
Off
Drive
ready for insertion or removal.
NOTE: The drive status indicator
remains off until all hard drives are initialized after the system
is turned on. Drives are not ready for insertion or removal during
this time.
Flashes
green, amber, and turns off
Predicted
drive failure
Flashes
amber four times per second
Drive
failed
Steady
green
Drive
online
Flashes green for three seconds, amber for
three seconds, and turns off after six seconds
Rebuild aborted
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
