- Notes, cautions, and warnings
- PowerEdge FC430 system overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing sled components
- Safety instructions
- Recommended tools
- Sled
- Inside the sled
- Cooling shroud
- System memory
- PCIe mezzanine card
- Internal Dual SD Module (IDSDM) card
- SD vFlash card
- LAN on Motherboard (LOM) riser card
- Processors
- Processor blank and DIMM blank
- Solid State Drives (SSD)
- Solid State Drive (SSD) backplane
- System battery
- System board
- Trusted Platform Module
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Getting help
Dell PowerEdge FC430 Owner's Manual
Processors
The CPU contains memory, peripheral interfaces, and other components of the system.
Your system supports up to two Intel Haswell EP product family processors or Broadwell-EP 2S product family processors.
NOTE: The sled supports the
following processors:
- Up to two 120 W processors are supported.
- A single 140 W processor is supported.
NOTE: Mixing
processors of different wattages is not supported.
Use the following
procedure when:- Installing an additional processor.
- Replacing a processor.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\