Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell PowerEdge R730xd Owner's Manual

PDF

Removing the system cover

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Turn off the system, including any attached peripherals.
  3. Disconnect the system from the electrical outlet and disconnect the peripherals.
  4. If installed, remove the optional bezel.

Steps

  1. Rotate the latch release lock counter clockwise to the unlocked position.
  2. Lift the latch toward the back of the system.
    The system cover slides back and the tabs on the system cover disengage from the slots on the chassis.
    NOTE: The position of the latch may vary depending on the configuration of your system.
  3. Hold the cover on both sides, and lift the cover away from the system.
    Figure 1. Removing the system cover
    This figure shows removing the system cover.
    1. system cover
    2. latch
    3. latch release lock

Next steps

  1. Install the system cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\