- Notes, Cautions, and Warnings
- Introduction
- Command | Configure
graphical user interface
- Accessing Command | Configure from Microsoft Windows system
- Accessing Command | Configure from Linux
- Files and folders of Command | Configure
- Accessing the Command | Configure GUI
- Creating a BIOS
package using GUI
- Configuration options
- Configuring the setuppwd and syspwd passwords
- Clearing setup and system passwords
- BIOS setup or system password screen
- Password protection screen
- Configuring the autoon option
- Configuring the bootorder option
- Configuring the primarybatterycfg option
- Configuring the advbatterychargecfg option
- Configuring the peakshiftcfg option
- Advanced System Management
- BIOS option validation
- Exporting the BIOS configuration
- Target system configuration
- Log details in Package History
- Troubleshooting
Dell Command | Configure Version 3.0 User's Guide
Validating a multiplatform package or saved package
On the
Create Multiplatform Package screen, click
Validate.
- If the option and the configured value are supported on the host system, then a green check mark is displayed in the Status column.
- If the option is supported and if the configured value is not supported on the host system, then a red X mark is displayed in the Status column.
- All unsupported options are greyed out and the Status column remains blank.
- All the supported options on the host system are highlighted and the Status column remains blank with the Value to Set field as Not Specified.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\