To configure
Remote Access Device users using the Remote Access page:
Click the Modular Enclosure > System/Server Module > Main System
Chassis/Main System > Remote Access object.
Click the Users tab.
The Remote Access Users window displays
information about users that can be configured as BMC/iDRAC users.
Click User ID to configure a new
or existing BMC/iDRAC user.
The Remote Access User Configuration window allows you to configure a specific BMC/iDRAC user.
Specify the following general information:
Select Enable User to enable the user.
Enter the name for the user in the User Name field.
Select the Change Password check box.
Enter a new password in the New Password field.
Re-enter the new password in the Confirm New Password field.
Specify the following user privileges:
Select the maximum LAN user privilege level limit.
Select the maximum serial port user privilege granted.
Specify the User group for DRAC/iDRAC user privileges.
Click Apply Changes to save changes.
Click Back to Remote Access User Window to go back to the Remote Access Users window.
NOTE: Six additional
user entries are configurable when DRAC is installed. This results
in a total of 16 users. The same username and password rules apply
to BMC/iDRAC and RAC users. When DRAC/iDRAC6 is installed, all the
16 users entries are allocated to DRAC.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\