Dell EMC OpenManage Command Line Interface Guide Version 9.1

omconfig Change Controller Properties

Table 1. omconfig Change Controller Properties . The following table describes the process to change any or all of the controller properties.
Description	Changes any or all of the controller properties.
Syntax	`omconfig storage controller action= setchangecontrollerproperties controller=<id> bgirate=<rate> reconstructrate=<rate> checkconsistencyrate=<rate> rebuildrate=<rate> clearredundantpath=clear abortcheckconsistencyonerror=<enabled \| disabled> loadbalance=<auto \| disabled> allowrevertiblehotspareandreplacemember=<enabled \| disabled> autoreplacememberonpredictivefailure= <enabled \| disabled> persistenthotspare=<enabled \| disabled> nrdiskcachepolicy=<enabled \| disabled \|unchanged>`
Example to Example	Enable revertible hot spare and replace member operation. `omconfig storage controller action= setchangecontrollerproperties allowrevertiblehotspare andreplacemember=enabled controller=1`
Example to Example	Allows to enable, disable, or not to change the Non-RAID Hard Disk Drives. This is applicable only to Disk Cache Policy. `omconfig storage controller action= setchangecontrollerproperties controller=1 nrdiskcachepolicy=enabled`