- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Recommended tools
- Subscriber Identification Module (SIM) card
- SD card
- Base cover
- Battery
- Solid State Drive (SSD)
- PCIe Solid State Drive (SSD)
- Speaker
- Coin cell battery
- WWAN card
- WLAN card
- Memory modules
- Heat sink
- Power connector port
- Dock frame
- System board
- Keyboard
- Display assembly
- Display bezel
- Display panel
- Display hinges
- eDP cable
- Camera
- Palmrest
- System Setup
- Boot Sequence
- Navigation keys
- System setup options
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel Software Guard Extensions screen options
- Performance screen options
- Power Management screen options
- POST Behavior screen options
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System Log screen options
- Updating the BIOS
- System and setup password
- Diagnostics
- Specifications
- Contacting Dell
Dell Latitude E7470 Owner's Manual
Installing the battery
- Align the tabs on the battery with the slots
on the palmrest.
NOTE: Ensure that the battery cable is routed through the routing clips on the battery.
- Tighten the screws to secure the battery to
the computer.
NOTE: The number of screws will vary depending on the type of battery.
- Connect the battery cable to the connector on the system board.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\