Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R230 Owner's Manual

PDF

Removing the expansion card riser

Prerequisites

  1. Disconnect the PERC card LED cable.

    NOTE: : This step is applicable only to the cabled hard drive systems.

  2. Follow the safety guidelines listed in the Safety instructions section.
  3. Follow the procedure listed in the Before working inside your system section.

Steps

  1. Lift and rotate the expansion card riser latch to open it.
  2. Holding the touch points, lift the expansion card riser from the riser connector on the system board.
    Figure 1. Removing and installing the expansion card riser
    This figure shows removing and installing the expansion card riser.
    1. expansion card riser
    2. touch point (2)
    3. expansion card latch
    4. guide slot on the chassis
    5. riser connector on the system board
    6. guide pin on the system board
    7. guide slot on the expansion card riser

Next steps

  1. Install the expansion card riser.
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\