Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge R830 Owner's Manual

PDF

Removing the integrated storage controller card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the cooling shroud.
  4. Keep the Phillips #2 screwdriver ready.

Steps

  1. Lift the expansion card latch out of the slot.
  2. Pull and slide the card out from the connector on riser card 3.
    Figure 1. Removing the integrated storage controller card
    This figure shows removing the integrated storage controller card.
    1. storage controller card
    2. expansion card latch
    3. riser card 3
    4. SAS cable (2)
  3. Disconnect the cables connected to the card by performing the following steps:
    1. Press the latch on the SAS cable connector.
    2. Pull the SAS cable out of the connector.
  4. If you are removing the expansion card permanently, install the filler bracket.

Next steps

  1. If applicable, install the integrated storage controller card.
    NOTE: Ensure that the H330, H730, H730P, or HBA330 card is installed only on slot number seven of the expansion card riser.
  2. Install the cooling shroud.
  3. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\