Align the notch on the WLAN card with the tab
on the WLAN-card connector on the I/O board.
Align the bracket which secures the WLAN card
to the palmrest assembly.
Connect the antenna cables to the WLAN card.
CAUTION:To avoid damage to the WLAN card, do not place any
cables under it.
NOTE: The color of the antenna
cables is visible near the tip of the cables. The antenna-cable color
scheme for the WLAN card supported by your computer is as follows:
Table 1. Antenna-Cable
Color Scheme for the WLAN Card
Connectors on the WLAN card
Antenna-cable color
Main (white triangle)
white
Auxiliary (black triangle)
black
Multiple input, multiple output (grey triangle)
Grey (optional)
Tighten the screw to secure the bracket and
the WLAN card to the palmrest assembly.
Install the:
battery
base cover
Follow the procedures in
After Working Inside
Your Computer.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\