Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FX2 and FX2s Enclosure Owner's Manual

PDF

Removing the CMC module

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: You must remove the CMC module to replace a faulty module or service other components inside the system.
NOTE: The CMC module is hot-swappable.

Ensure that you read the Safety instructions.

Steps

  1. Disconnect the cables attached to the CMC module.
  2. Press the release latch and slide the CMC module out of the enclosure.
    Figure 1. Removing and installing the CMC module
    This figure shows removing and installing the CMC module.
    1. CMC module
    2. CMC module handle
    3. release latch

Next steps

Install the CMC module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\