Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FC830 Owner's Manual

PDF

Installing a 1.8-inch (x16) SAS SSD backplane

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: The 1.8-inch (x16) SSD backplane is a full-length backplane with two backplane cables. The connector on one of the backplane cables connects the SSDs populated in bays 0–7, to the connector on the system board (J_PERC) through the expander card. For more information about installing the expander card, see the Expander card section. The connector on the other backplane cable connects the SSDs populated in bays 8–15, to the connector on the system board (SATA_BP).
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the #2 Phillips screwdriver ready.

  4. Remove the SSD backplane.
    NOTE: You must remove the SSD backplane to replace a faulty SSD backplane or service other components inside the system.

Steps

  1. Align the two retention screws on the backplane cable connector with the two screw holes on the system board connector (SATA_BP).
  2. Tighten the two retention screws to secure the backplane cable connector on the system board.
  3. Align the retention screw on the backplane cable connector with the screw hole on the expander card connector (EXP).
  4. Tighten the retention screw to secure the backplane cable connector on the expander card.
  5. Install the SSD cage.
  6. Align the guides on the SSD backplane with the guide pins on the SSD cage.
  7. Lower the SSD backplane into place until the guide pins on the SSD backplane engage with the guides on the SSD cage.
  8. Tighten the retention screws to secure the SSD backplane on the system board.
  9. Connect the power cable to the backplane.
    Figure 1. Installing a 1.8-inch (x16) SAS SSD backplane
    This image shows installing a 1.8-inch (x16) SAS SSD backplane.
    1. power cable
    2. alignment pin
    3. retention screw on the top of the backplane (3)
    4. backplane cable (2)
    5. backplane cable connector that connects to the connector on the expander card
    6. backplane
    7. guide pin (3)
    8. backplane cable connector that connects to the connector on the system board
    9. SSD cage

Next steps

  1. Install the SSDs in their original locations.

  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\