- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Technical overview
- Removing the side panel
- Replacing the side panel
- Removing the wireless card
- Replacing the wireless card
- Replacing the optical drive
- Removing the optical drive
- Removing the memory module
- Replacing the memory module
- Removing the hard drive
- Replacing the hard drive
- Removing the graphics card
- Replacing the graphics card
- Removing the solid-state drive
- Replacing the solid-state drive
- BIOS setup program
- Flashing the BIOS
- Getting help and contacting Alienware
Alienware X51 Service Manual
Procedure
- Align the graphics-card assembly with the slot on the riser cage.
- Place the graphics-card assembly in the slot and press down firmly. Ensure that the graphics-card assembly is seated in the slot.
- Rotate the card retention bracket towards the riser cage until it snaps into place.
- Route the graphics-card power cables through the routing guide on the riser cage.
- Align and press down the riser cage until the riser card slides into the riser-card slot on the chassis.
- Replace the screws that secure the riser cage to the chassis.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"