Omitir para ir al contenido principal
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.

Dell PowerEdge FC430 Owner's Manual

Removing an internal SD card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Enter System Setup and ensure that the Internal SD Card Port is enabled.

NOTE: When an SD card failure occurs, on the next reboot, the system displays a message indicating the failure.

Steps

  1. Locate the SD card slot on the internal dual SD module (IDSDM) card.
  2. Press the card to release it from the slot and remove the card.
    Figure 1. Replacing an internal SD card
    This figure shows removing an internal SD card.
    1. SD card slot
    2. SD card

Next steps

  1. Follow the procedure listed in the After working inside your system section.
  2. Enter System Setup and ensure that the Internal SD Card Port is enabled.

  3. Check if the new SD card is functioning properly. If the problem persists, see the Troubleshooting an Internal SD Card section.


Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"