Use the following instructions to attach the client
to the E-series mount:
Preparing the client—Use a Phillips-head
screwdriver to remove the filler screws from the side of the client
and replace them with the shoulder screws.
Removing
the cover plates and screws from the monitor.
Place the monitor panel face down on a soft cloth
or cushion.
Remove cover plate if present.
Remove the monitor screws from the back of the monitor,
and use them when you proceed with installation later.
NOTE: During installation,
position the monitor with the base of the stand hanging over the edge
of the table.
Attaching the base extender—Slide the
base extender onto the monitor stand and use the screws provided in
the tool kit to secure the base extender to the monitor stand.
CAUTION: Do not
overtighten the screws.
Attaching
E-series mount to the monitor
—
Position the E mount
on the back of the monitor and attach it by using the monitor screws
at 4 locations.
CAUTION: Do not
overtighten the screws.
Attaching the client—Slightly tip the
client to align and insert the four protruding shoulder screws into
the cutout areas of the E-series mount. Slide the client until it
snaps into place. The security latch moves automatically when the
shoulder screws are inserted. The security latch is marked with the
number
1 in the following image.
CAUTION: The power button should face towards the security latch
and air vents should face outwards for proper heat dissipation.
1. Security latch
Connecting cables—To complete your setup, make
all the desired connections, and then plug the AC power cord into
an AC wall outlet.
NOTE: To remove the
client, gently pull the security latch to the right to release shoulder
screws and slide the client from mount.
Los datos no están disponibles para el tema
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"