Dell OpenManage Server Administrator Version 7.3 User's Guide

Configuring Remote Access Device Users

To configure Remote Access Device users using the Remote Access page:

Click the Modular Enclosure > System/Server Module > Main System Chassis/Main System > Remote Access object .
Click the Users tab.
The Remote Access Users window displays information about users that can be configured as BMC/iDRAC users.
Click User ID to configure a new or existing BMC/iDRAC user.
The Remote Access User Configuration window allows you to configure a specific BMC/iDRAC user.
Specify the following general information:
- Select Enable User to enable the user.
- Enter the name for the user in the User Name field.
- Select the Change Password check box.
- Enter a new password in the New Password field.
- Re-enter the new password in the Confirm New Password field.
Specify the following user privileges:
- Select the maximum LAN user privilege level limit.
- Select the maximum serial port user privilege granted.
- On Dell PowerEdge 9G systems, select Enable Serial Over LAN to enable Serial Over LAN.
Specify the User group for DRAC/iDRAC user privileges.
Click Apply Changes to save changes.
Click Back to Remote Access User Window to go back to the Remote Access Users window.
- NOTE: Six additional user entries are configurable when DRAC is installed. This results in a total of 16 users. The same username and password rules apply to BMC/iDRAC and RAC users. When DRAC/iDRAC6 is installed, all the 16 users entries are allocated to DRAC.