- Notes, Cautions, and Warnings
- Copyright
- Introduction
- Preinstallation Setup
- Installing Managed
System Software On Supported Linux And VMware ESX
- Software License Agreement
- RPM For Individual Components
- OpenIPMI Device Driver
- Installing Managed System Software
- Uninstalling Managed System Software
- Installing Systems
Management Software On VMware ESXi
- Using The vSphere CLI
- Using The VMware vSphere Management Assistant (vMA)
- Using The VMware Update Manager (VUM)
- Using The Power CLI
- Accessing Server Administrator on VMware ESXi
- Enabling Server Administrator Services On The Managed System
- Configuring The SNMP Agent On Systems Running VMware ESXi
- Troubleshooting
- Frequently Asked Questions
- Linux Installer Packages
Server Administrator Version 7.4 Installation Guide
Running sfcb And openwsman
Run sfcb and openwsman:
- /etc/init.d/sfcb start
- /etc/init.d/openwsmand start
On Red Hat Enterprise Linux 6, for the sblim-sfcb and openwsman to start automatically after a reboot you need to change the run-levels using the chkconfig utility. For example, if you want to run sblim-sfcb in run-levels 3 and 5, use the following command:
#chkconfig sblim-sfcb on --level 35
The managed system is configured and is ready to be used by the Server Administrator Web Server.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"