Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.

Inspiron 14 3000 Service Manual

PDF

Procedure

  1. Remove the screws that secure the palm-rest assembly to the computer base.
  2. Lift the latches and disconnect the touch-pad cable and power-button cable from the system board.
    Image: Removing the palm rest
    1. power-button cable
    2. screws (5)
    3. palm-rest assembly
    4. computer base
    5. touch-pad cable
    6. latches (2)
  3. Close the display and turn the computer over.
  4. Remove the screws that secure the palm-rest assembly to the computer base.
  5. Disconnect the speaker cable from the system board.
    Image: Removing the palm rest
    1. screws (8)
    2. computer base
    3. speaker cable
  6. Lift the computer base and pry the palm-rest assembly off the computer base using a plastic scribe.
    Image: Removing the palm rest
    1. computer base
    2. palm-rest assembly
    3. plastic scribe
  7. Turn the computer over and open the display as far as possible.
  8. Lift the palm-rest assembly at an angle and remove it from the computer base.
    Image: Removing the palm rest
    1. palm-rest assembly
    2. computer base
  9. Follow the procedure from step 1 to step 6 in “ Removing the touch pad ”.
  10. Follow the procedure from step 1 to step 4 in “ Removing the power-button board ”.
  11. Follow the procedure from step 1 to step 4 in “ Removing the speakers”.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\