- Notes, cautions, and warnings
- Copyright
- Introduction
- Getting started: Basics
- Configuring thin client settings locally
- Configuring
Connections locally
- Configuring and managing the browser connections
- Configuring and managing Citrix connections
- Configuring and managing VMware connections
- Configuring and managing RDP connections
- Configuring and managing the custom connections
- Configuring and managing the SSH connections
- Configuring and managing the VNC viewer connections
- Configuring and managing the Ericom PowerTerm connections
- Security settings
- Additional management configurations
- Viewing XTerm
- Imaging solutions
- Central Configuration: Automating Updates and Configurations
- DHCP options tags
- Mixed Environment Imaging – An Enhanced Method of Upgrading
Bienvenue
Bienvenue dans l’univers Dell
Mon compte
- Passer des commandes rapidement et facilement
- Afficher les commandes et suivre l’état de votre expédition
- Créez et accédez à une liste de vos produits
- Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Dell Wyse ThinLinux 1.0.3 Administrator’s Guide
Configuring and managing the custom connections
The
Custom
Connections
page enables you to create and manage the Custom connection
based on shell commands. The main Custom page has options to create
a Custom connection.
- Click the + icon to add a new Custom Connection. The Custom Connections page is displayed.
- The following options must be configured in
the
Login tab.
- Enter the shell command. The shell command is performed when you click the connection icon on the desktop.
- Click the ON/OFF button to enable or disable the Auto-connect after login option. If enabled, the connection is automatically connected after you log in to your thin client.
- Click the ON/OFF button to enable or disable the Auto-reconnect after disconnected option. If enabled, the connection is automatically re-connected after you disconnect from the session.
- Select the amount of time in seconds to delay the reconnection attempt after a disconnection occurs.
- The following options must be configured in
the
Experience tab.
- Click the ON/OFF button to enable or disable the Run in terminal window option.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\