Passer au contenu principal
Quitter

Bienvenue dans l’univers Dell

Mon compte
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Se connecter Créer un compte Connexion au compte Premier Connexion au programme de partenariat

Vos paniers Dell.com

Dell Chassis Management Controller Version 3.0 for Dell EMC PowerEdge VRTX User's Guide

PDF

Checklist To Set up Chassis

The following tasks enable you to accurately set up the chassis:
  1. CMC and the management station, where you use your browser, must be on the same network, which is called the management network. Connect an Ethernet network cable from the CMC active port to the management network.
  2. Install the I/O module in the chassis and connect the network cable to the chassis.
  3. Insert the servers in the chassis.
  4. Connect the chassis to the power source.
  5. Press the power button, or turn on the chassis from the CMC web interface after completing the task in step 7.
    NOTE Do not turn on the servers.
  6. Using the LCD panel, navigate to the IP Summary and click on the Check button to select. Use the IP address for the CMC in the management system browser (IE, Chrome, or Mozilla). To set up DHCP for CMC, use LCD panel to, click Main Menu > Settings > Network Settings.
  7. Connect to the CMC IP address by using a web browser by typing the default username (root) and password (calvin).
  8. Provide each iDRAC with an IP address in the CMC web interface, and enable the LAN and IPMI interface.
    NOTE iDRAC LAN interface on some servers are disabled by default. This information can be found on the CMC web interface under Server Overview > Setup. This might be an advanced license option; in which case you must use the SetUp feature for each server).
  9. Provide the IO module with an IP address in the CMC web interface. You can get the IP address by clicking I/O Module Overview, and then clicking Setup.
  10. Connect to each iDRAC through the Web browser and provide final configuration of iDRAC. The default user name is root and password is calvin.
  11. Connect to the I/O module by using the web browser and provide final configuration of the IO module.
  12. Turn on the servers and install the operating system.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\