Ugrás a fő tartalomra
Kijelentkezés

Üdvözli a Dell!

Saját fiók
  • Rendelésfeladás gyorsan és egyszerűen
  • Rendelések megtekintése és a kiszállítási állapot követése
  • Terméklista létrehozása és elérése
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Bejelentkezés Fiók létrehozása Premier bejelentkezés Partnerprogram – bejelentkezés
Kapcsolatfelvétel

Dell OpenManage Server Administrator Version 7.3 Command Line Interface Guide

PDF

Omreport Controller Status

The following table describes the syntax for the omreport Controller commands
Table 1. Omreport Controller Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage controller   Displays property information for all controllers attached to the system.
  controller=id, where id is the controller number. For example, controller=0 Displays the specified controller and all attached components such as enclosures, virtual disks, physical disks, and so on.
  controller=id info=foreignkeyids Displays the locked foreign configuration information for import or clear operations.
  controller=id info=pdslotreport
Displays the empty and occupied slot details of enclosures in the controller.
  • NOTE: This command is not supported on Blackplane, SCSI, and SWRAID controllers.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\